A wildlife recorder runs on a battery rated at 128 watt-hours. Turning it on consumes 5 watt-hours immediately; the remaining energy powers a repeating 10-minute cycle. During each cycle it listens for eight minutes at 15 watts, then transmits for two minutes at 60 watts.
The field team will only count a session as complete if it ends after a transmission, not partway through a cycle. Assume the battery delivers its full rated energy and both power draws stay constant. What is the longest complete session the team can run on a fresh battery? Show why one more cycle is impossible.
Get hint
Hint 1
Convert each operating mode’s watts and minutes into energy in watt-hours before adding them.
Show solution
Power multiplied by elapsed time gives energy. The eight-minute listening portion consumes \(15\times(8/60)=2\) Wh; the two-minute transmitting portion consumes \(60\times(2/60)=2\) Wh. Each complete 10-minute cycle therefore requires 4 Wh.
Startup takes 5 Wh once, leaving \(128-5=123\) Wh. For an integer number \(n\ge0\) of full cycles, the energy limit is
\[
5+4n\le128 \quad\Longleftrightarrow\quad n\le\frac{123}{4}=30.75.
\]
The maximum possible integer is \(\boxed{n=30}\). It provides \(30\times10=\boxed{300\text{ minutes}=5\text{ hours}}\) of complete operation. Total consumption is \(5+4(30)=125\) Wh, leaving 3 Wh; a 31st cycle would use \(5+4(31)=129\) Wh, one Wh too much.
Taking the unweighted average of 15 and 60 watts would be incorrect because the two power modes run for different lengths of time. Counting a partial 31st cycle would also violate the full-cycle condition.
Assumptions
Watt-hours equal watts multiplied by hours.
The 5 Wh start-up consumption happens once, before any 10-minute operating cycle.
Only nonnegative whole numbers of complete cycles are allowed.
Final Answer
30 complete cycles, lasting 300 minutes (5 hours). Startup plus 30 cycles uses 125 Wh; a 31st would require 129 Wh, above the 128 Wh capacity.